1. 29896 Baltic Ct AMANDEEPKAUR Phone: (510)723-4041
Hayward, CA 94544 Email: punjabanproud2011@gmail.com
EDUCATION________________________________________________________________________________________________________
B.S. Electrical Engineering A.S. Mathematics
UC San Diego, Graduated: March 2015 Chabot Community College, Hayward, CA
Cumulative GPA: 3.13 Graduated: May 2012, GPA: 3.80
Relevant Coursework:
Linear Systems Fundamentals
Digital Integrated Circuit Design
Analog Integrated Circuit Design
Microwave Systems & Circuits
Introduction to Power Electronics
Digital Signal Processing I
INTERNSHIP EXPERIENCE___________________________________________________________________________________________
Hardware Engineering Intern
Seacomp, Carlsbad, CA April 2014- Sept 2014
• Used Altium CAD tools to build schematic and laying out PCB design of display projects
• Prototyped and tested FReal Cape LCD display sub-circuit to enable read/write onto the chip
• Prototyped and tested backlight driver circuit
• Obtained experience using industrial soldering tools to solder and DE solder the components of integrated circuits on PCB
Advanced Manufacturing Intern
Combined Power, Santee, CA Jan 2014- March 2014
• Built and tested the low-pass RC filter to reduce the noise in the signal that was reading the flow of water
• Soldered the low-pass RC filter to the input wire to suppress the noise caused by higher frequencies
• Polished the back side of the mirrors with coating to prevent them from corroding in water
PROJECT EXPERIENCE______________________________________________________________________________________________
Datalogger
Cubic Transportation Systems, UCSD Project Jan 2015- Present
• Tested and implemented current sensor and temperature sensor to add to the mobile validator
• Tested the RF signal read by two turns coil for the Amplitude modulation and measured the rise time
• Implemented band pass filter, rectifier and comparator circuits to read the signal and card’s response in field.
• Used ExpressPCB to finish the schematic and layout of the design
Carry-Skip Adder May 2014-June 2014
Digital Integrated Circuit Design, UC San Diego
• Implemented Carry-Skip algorithm to add 8 bits and reduced the worst case delay
• Finished the transistor level layout of 8-bit Carry-Skip adder and also cleared off all DRC and LVS errors
Viacar Project
IEEE Project, UC San Diego Nov 2013- May 2014
• Worked on motor controller to apply PWM to control the speed of car
• Designed, tested and debugged Half-Bridge circuit to control forward, reverse and breaking functions of car
TECHNICAL SKILLS_________________________________________________________________________________________________
Software Skills
Altium, ExpressPCB, MATLAB, C++, C, MS Office (Word, Excel, PowerPoint), PSpice, Simplorer, ORCAD
Hardware Skills
• Function Generator, Oscilloscope, DMM, Soldering Iron
HONORS____________________________________________________________________________________________________________
• Excellence award in writing- MMW Research paper, UCSD, 2012-2013
• Provost’s Honors, Winter 2013, Spring 2013
• Member of Eta Kappa Nu, Winter 2014-Present
LEADERSHIP SKILLS________________________________________________________________________________________________
• ICC Representative, Alpha Gamma Sigma Honors Society at Chabot College, Hayward, CA Jan 2012-May 2012
• Staff Member, IEEE at UCSD, Fall 2013- Winter 2013
PERSONAL SKILLS__________________________________________________________________________________________________
• US Citizen
• Writes and speaks English, Hindi and Punjabi fluently