4. -
3
Drop Test
-Dynamic
PASS
6inch drop
1)225ib drop at highest &lowest
seat position
2) 300ib drop at highest &lowest
seat position
4
Stability
Tests
PASS
Load the chair with 13 disks
(See Appendix B). Place the
first disk on the seat so it
touches the support fixture.
As each disk is added to the
stack slide it along the lower
disk until
it contacts the support fixture
as shown in Figure 12b. As
each disk is added, the
backrest may
move such that the lower
disks do not remain against
the support fixture; this is
acceptable, do
not reposition the disks.
If the chair does not tip over
and the tilt mechanism does
not tilt to its most rearward
position
(i.e., at its tilt stop) when the
disks are placed in the chair,
the chair shall also be tested
according to 12.3.1 with the
chair in the unlocked position
5. -
5
Stability
Tests-
FRONT Sec
12.4
PASS
Apply a vertical load of 600 N
(135 lbf.), by means of the
front stability loading fixture
shown in Figure 12g at a point
60 mm (2.4 in.) from the front
center edge of the
loadbearing
surface of the chair.
6 Arm
Strength
Test-
Horizontal -
Static
PASS 1 minute with 100ib,1 minute
with 150ib.
7. -
Notice:
Disposition of Testing Product: The Test Lab will keep these samples for one week after testing,
and then the samples will be disposed without further notice.
The test report cannot be copied except in full and the test results apply only to item(s) tested.
*************************** End of Report *******************************