1. Here I have just started making my Lightbot, this is it’s head, The thing I found difficult about making
this was beveling it because I had to try making all the angles look right.

2. This is a joint for my Lightbot’s arms and logs, this was easier to make than the head since it was a
smaller object.

3. This is the arm and the leg, this was the easiest thing to make because all I had to do was make a
circle and bevel it up.

4. Like the head, this was also hard to make, this is due to bevelling to get all the angles right, I also had
to make it look smooth by beveling.

5. This is the Lightbot’s hand, what I had to do here was make the main shape of the hand in 2D, then I
bevel it down to make it look 3D, that’s why it looks well done, I had to make the sphere at the top
by bevelling a circle, I used a spare circle to bevel so I could make the sphere connect to the hand
itself.

6. This is what goes inside the Lightbot’s head; this was even harder to do than the actual head since
there was a lot more bevelling to do.

7. This is the Lightbot’s foot, what I had to do for this was make a rectangle, make more points on one
side of it so it can look round, then I had to shorten the side of the foot that is rounded,, then I bevel
down and out about 4 – 5 times, then I just bevel down.

8. And now I put the pieces of the Lightbot together to make the Lightbot itself.

9. This is my finished Lightbot.