1. REVIEWS - 9" Carbide Brushcutter - Trimmer
Blades 4pk
ViewUserReviews
Average Customer Rating
5.0 out of 5
Product Feature
Pack of {4} -- Carbide Tipped Trimmer Brushcutterq
Blades 9" diameter - 100 Teeth brazed-welded
9" will fit with Blade Guard {OFF} for maximumq
cutting but less safety. Carbide is estimated to last
approx. 10x longer than plain steel
Our 9" is estimated to last approx 10%-12% longerq
than our 8" due to 20% more teeth (therefore
more aggregate cutting surface)
but will {NOT} allow {most} blade guards to fitq
since blade diameter is larger than standard... but
offers the tradeoff of more performance
Read moreq
Product Description
UNIVERSAL FIT: ***NEW Thinner Reducer Washer***. You can measure "Washer" thickness with a Caliper, the
Washer is the exact thickness of the blade and will even smash somewhat when firmly tightened. This blade
will fit any Trimmer-Brush cutter that takes a 1" = 25.4mm or 7/8" = 20mm arbor. Our blade is built for any
RPM even super high RPM Trimmers (10,000+ rpm). Manufactured with a more flexible steel as compared to
the much more brittle steel found with table saw blades (table saw blades can shatter if they hit an obstacle,
plus they are only built for approx. 3,450 rpm so they should never be used with Gasoline powered Garden
Trimmers). The carbide tips are welded-brazed on and will not come off.--- NOTE: sorry, but we have NO
answers regarding your particular Trimmer/brush cutter. It is up to you to determine whether: (1) a Blade can
even be attached to your Trimmer. (2) what blade attachment hardware is available for your Trimmer such as:
fittings, blade guards, or attachments. (3) The arbor size it takes. This is the hole in the middle of the blade,
sizes we offer are mentioned above and are the most standard in the industry. (4) Our blades will outperform
any 40 tooth blade, as we offer over twice the aggregate cutting surface due to Two or Three times as many
CARBIDE teeth. More Carbide for the same buck means VALUE and DURABILITY. (5) NOTE: Jagged teeth do
nothing since at high RPM's, cutting material does not sink into teeth cavities, and less teeth are prone to
tearing cuts with lots of seizing in limbs... only the outer teeth tips do the cutting, our blades are the smoothest
cutting in the industry. Try pruning a hedge with a 40 tooth then try ours, you will see what we are saying. The
CARBIDE MIX in our teeth is 2nd to none, take the test challenge. Just Tungsten is not enough; additives like:
Hafnium, Tantalum, Titanium, Molybdenum, Silicone, Zirconium, Boron, Niobium, Chromium, & Vanadium,
make for a better Carbide Mix for longer lasting teeth. Read more
2. You May Also Like
9" Carbide Brushcutter - Trimmer Blades 3pk
9" Carbide Brushcutter - Trimmer Blades 2pk