Go for plaque mounting printer or posters materials on MDF today. Ordering for the materials is a very easy task to undertake. Companies that provide these services will need you to upload it through their site in case you have a digital copy of the original photo
Ordering Plaque Mounting Printer or Poster Material on MDF is Finished- You Can’t Miss this
1.
2. Plaque mounting is very affordable compared
to other alternatives. There is no need for
glare or glass. The print is attached
permanently and it cannot wrinkle, fade or
buckle. The edges are finished with unique
and different colors that allow activate a
frame-free contemporary look allowing it to
be hanged on the wall.
3. In plaque mounting there
are several techniques that
are used as follows:
• Classic tape
• Self-adhesive backed photo
corner.
• Dry picture mounting
technique.
• Wet mounting method.
• Spray mounting method.
4. • When block mounting
those that provide
these services will
require the following:
• Measuring tape.
• Medium density fiber
board.
• Art print or photograph.
5. The following is step by step guidelines:
• First they, measure the photograph or art print then mark the
medium density fiberboard. Cut the MDF using the carbide
blade and using grit sandpaper cut the corners of the medium
density board.
6. • Then they build 1 by 1 cm thick frame which is
placed 2 inches from the corner of the board
at the back of the board that you are using.
This will stop the board from flexing.
• Spray adhesive on the board and make sure
you don’t miss any single spot. Spray another
coat after ten minutes and at the back of the
poster, then swiftly place the poster on the
board as you attempt to center it.
7. • Using a straight edge tap the mounted posters moderately
across the board.
• After that, they leave it for up to 5-6 hours and then check
to make sure the poster has not lifted and it has roll and
press until the air pockets are not seen anymore.
8. Then they find polythene in a matte finish spray and spray it.
They ensure the place is properly ventilated and that it is not
soaked. After 24 hours of drying they do the poly once again.
9. After 2 days, individuals in
this business head and check
to find out if the paper has
lifted. Then utilizing a router
that has a straight cutting
bit, they set a straight corner
guide which will leave with a
1/8 gap. The gap is between
the corner of the poster and
the edge of the board.
10. • So as to have a nice beveled
edge, one has to go round the
edges using a 45 degree bit
for router. The poster is
covered leaving the freshly
cut edge seaming exposed.
• Later, they get a spray paint
and utilize it to spray the
corners of the MDF before
removing the tape.
• If you are looking for one of
the best marketing ideas, you
should consider mounted
posters.
11. You can also send your original photos through
mail. If you are a local customer feel free to
take the photos to their stores personally.
