Setting up the Raspberry Pi Using BerryBoot
•Télécharger en tant que PPTX, PDF•
0 j'aime•1,951 vues
These slides walk you through taking the Raspberry Pi from the box to a usable system, using the BerryBoot software.
Recommandé
Contenu connexe
Plus de Gary Short
Setting up the Raspberry Pi Using BerryBoot
- 1. Setting up the Raspberry Pi Using BerryBoot… Gary Short Head of Gibraltar Labs @garyshort
- 2. Who the Hell’s this Guy? • Gary Short • Head of Gibraltar Labs – Skunk works division of Gibraltar Software • Social Network Analysis and Computational Linguistics research • @garyshort • Facebook.com/theothergaryshort • gary.short@gibraltarsoftware.com
- 3. The Pi Comes in a Box Like This…
- 4. And Looks Like This…
- 5. But You’re Going to Want to Put it in a Case Like This…
- 7. Your SD Card Comes in a Package Like This…
- 8. Put it in Your Card Reader…
- 10. Extract it to Your SD Card…
- 11. To Give You This…
- 12. Connect Everything and Fire up the Pi…
- 13. The BerryBoot Launcher Will Start…
- 14. Select Your SD Card as Install Destination…
- 15. The Bootloader and Firmware will Install…
- 16. If you are Asked to Update, you Probably Should…
- 17. Once you do, Reboot…
- 18. When You’re Back, Boot the OS Installer…
- 19. Select your OS…
- 20. There are lots to Choose from…
- 21. See…
- 23. Exit the Boot Menu Editor…
- 24. And Reboot…
- 25. You’ll be Presented with the Config Menu…
- 26. The Pi will Reboot… Note the IP address, we’ll need that later…
- 27. And you’re Done…