System Electronics designs iCON range of electronic pressbrake controller systems that offers ease of control with better programming. Contact us today to make an engineering assessment of you system and design a controller for the same.

1. Guide on Press Brake Controller
Electronic Connections
Published By : icontrol.net.au

2. Press brakes are used to make bends in varying thickness of
heavy sheets. This is essentially a machine that is used for
bending a metal sheet or plate, into a shape controlled by its die
set. It forms preset curves by firmly holding the workpiece
between the punch and die set. This is a multi purpose
fabricating machine and is suitable for several types of metal
forming operations. It has the capability to deliver force in a
constrained vertical space so as to punch or bend the metal
sheet.

3. A variety of press brakes are now available in the market
with each requiring long setup times. But with the
subsequent introduction of retrofitted CNCs and full CNC
brakes, setup time is greatly reduced. Setup and operation
of a press brake retrofit controller or a full CNC controller
require an alternate level of experience and information than
manual brake setup and operation.

4. Below is a guide of the electrical connections of the press that
allow them to work efficiently.
Earthing Techniques:
Cable Types:

5. Sound earthing techniques facilitate robust operation of the
controller with all signal cables including Analog Out, Analog In,
and Quadrature shielded.
An aluminum foil shield with drain wire is preferred the most,
with the drain wire connected to the terminals of the controller.
The controller will operate slightly differently with respect to
noise immunity and other general inference exciters.
Earthing Techniques:

6. Cable Types:
Maximum current for a signal connection should be
200mA.
Maximum current for a power terminal should be 6 amps.
Use low current carrying instrument cables whenever
possible.
Using high input current drives multistrand cable.

7. Each press brake machine component requires special
connections on its application. Find the
best press controller and improve the efficiency of your
machines to large extents.

8. Contact Us:
Australian Headquarters
System Electronics Pty. Ltd.
PO Box 6772,
Park Beach Plaza
NSW 2450
Australia
ABN 30 009 888 402
Sales sales@icontrol.net.au +61412 423 984
Support support@icontrol.net.au +61438 124 696

9. THANK YOU !!!
Please Visit Again...

10. THANK YOU !!!
Please Visit Again...