This document provides a guide for completing Worksheet 2. It outlines the steps to complete two exercises using sketching and extrusion tools in CAD software. Exercise 1 guides the user to click the Extruded Boss/Base icon, select a line in the figure, click OK, and change a value. Exercise 2 instructs the user to offset entities while in Sketch mode, follow Step 4, and observe how solid lines change. It also mentions filleting and shelling commands.

1. Guide for
Worksheet 2
This powerpoint will have step-by-step
guide. Look carefully where are the icons
and what are the common steps.

2. Exercise 1
Click Extruded Boss/Base

3. Click any line of figure after clicking
Extruded Boss/Base

4. Click OK here!
Change value here!

5. Completed exercise 1

6. Exercise 2
Offset
entities
seen only in
Sketching
mode

7. Follow
Step 4

8. Look at what did the
solid lines changes to?

10. Fillet

12. Shell

13. Select surface to “shell”

14. Finally…