SlideShare utilise les cookies pour améliorer les fonctionnalités et les performances, et également pour vous montrer des publicités pertinentes. Si vous continuez à naviguer sur ce site, vous acceptez l’utilisation de cookies. Consultez nos Conditions d’utilisation et notre Politique de confidentialité.
SlideShare utilise les cookies pour améliorer les fonctionnalités et les performances, et également pour vous montrer des publicités pertinentes. Si vous continuez à naviguer sur ce site, vous acceptez l’utilisation de cookies. Consultez notre Politique de confidentialité et nos Conditions d’utilisation pour en savoir plus.
Design and Analysis
Ancillary Hydraulic Devices
DR: Samir elshamy
DR : Samir elshamy1
DR : Samir elshamy2
Ancillary hydraulic devices
Are those important components that don't fall under the major
categories of :
pump ,actuator, conductor
These Ancillary devices are:
reservoir ,accumulator ,heat exchangers ,pressure gages ,flow
meter ,filters and strainers
DR : Samir elshamy3
The reservoir serves not only as storage space for the hydraulic fluid used by
system but also the principal location where the fluid is conditioned .
The reservoir is where the sludge ,water and metal chips settle and where
entered air picked up by the oil is allowed to escape .
The dissipation of heat is also accomplished by properly designed reservoir.
A vented breath cap is included and contains air filter screen ,this allows the
tank to breath as the oil level changes due to system demand requirements
Baffle plate extends lengthwise across the center of the tank, its height =70%
of the height of the oil level .
The purpose of the baffle is to separate the pump inlet line from return line
to prevent the same fluid from recirculating continuously within the tank
DR : Samir elshamy6
The baffle serves the following functions:
1) Permits foreign substances to settle to the bottom
2) Allows entrained air to escape from oil
3) Prevents localized turbulence in reservoir
4) Promotes heat dissipation through reservoir walls
The return line should enter the reservoir on the side plate that is opposite
from the pump suction line.
To prevent foaming of the oil , the return line should be installed within
two pipes diameter from the bottom of the tank.
The pump suction strainer should be below the normal oil level in the
reservoir ,if the strainer is located too high ,it will cause a vortex and
permit air to enter the suction line.
DR : Samir elshamy7
Sizing of reservoirs
The sizing of a reservoir is based on the following criteria:
1. It must make allowance for dirt and chips to settle and for air to escape
2. It must be able to hold all the oil that might drain into the reservoir from
the system .
3. It must maintain the oil level high enough to prevent a whirlpool effect at
the pump inlet .
4. It should have a surface area large enough to dissipate most of the heat
generated by the system
5. It should have adequate air space to allow for thermal expansion of the oil
Volume of the tank = 3 to 5 times of the pump flow rate
DR : Samir elshamy8
it is a device that stores potential energy by means of either gravity ,
mechanical spring or compressed gases
There are three type of accumulators :
1)Weight –loaded , or gravity type
3)Gas-loaded type which consists of
B.Separator type ,which consists of: