Cisco 400-101 CCIE Routing and Switching Certification Exam Training Guide

Exam Code: 400-101
Pass CCIE Routing and Switching
By Using www.realbraindumps.com Study Material

WhyChoose Us?
We KnowThere is a Question inYour
Mind that why we choose
www.realbraindumps.com to pass
our Certifications Exam….??? Simple
And StraightAnswer of Your
Question is shown in the Figure or
Chart Shown Here:
Realbraindumps
Guaranteed
Success
24/7
customer
support
Questions
same like
in the real
exam
Money
Back
Guarantee
www.realbraindumps.com

YourSuccessisGuaranteedWithUs
We assure you that if you use our
dumps for the preparations of your
Certifications Exams, then your
success is guaranteed. Because the
questions we provide are same like
in the real exam. So just visit us at
www.realbraindumps.com to pass
any certification exam with ease.
100%
Correct
Answers
All Dumps Are
Tested And
Approved
Free
Updates
for 120
days
99.3% Exam
Passing
Assurance
Just 1
day
study
required
Dumps Are 100%
Valid

TheListof Vendors:
We Provide Study Material
(Demos,Dumps,Questions &
Answers etc) For all most All the
Vendors that exists inCertification
Fields.The List ofThoseVendors is
Displayed Here:

Cisco400-101SampleQuestions
http://www.realbraindumps.com/400-101-braindumps.htmlComplete File is Here:
Question 1:
If you change the SpanningTree
Protocol from pvst to rapid-pvst, what
is the effect on the interface Fa0/1
port state?
A. It transitions to the listening state,
and then the forwarding state.
B. It transitions to the learning state
C. It transitions to the blocking state,
then the learning state, and then the
forwarding state.
D. It transitions to the blocking state
Answer: C

Question 2:
Which configuration is missing that would
enable SSH access on a router that is
running Cisco IOS XE Software?
A. int Gig0/0/0 management-interface
B. class-map ssh-class match access-group
protect-ssh policy-map control-plane-in
class ssh-class police 80000 conform
transmit exceed drop control-plane service-
policy input control plane-in
C. control-plane host management-
interface GigabitEthernet0/0/0 allow ssh
D. interface Gig0/0/0 ip access-group
protect-ssh in
Answer: C

Question 3:
ICMP Echo requests from host A are not
reaching the intended destination on host
B.What is the problem?
A. The ICMP payload is malformed.
B. The ICMP Identifier (BE) is invalid.
C. The negotiation of the connection failed.
D. The packet is dropped at the next hop.
E. The link is congested.
Answer: D

Question 4:
Which statement is true?
A. It is impossible for the destination
interface to equal the source interface..
B. NAT on a stick is performed on interface
Et0/0.
C. There is a potential routing loop.
D. This output represents a UDP flow or a
TCP flow.
Answer: C

Question 5:
Which action will solve the error state of
this interface when connecting a host
behind a Cisco IP phone?
A. Configure dot1x-port control auto on
this interface.
B. Enable errdisable recovery for security
violation errors.
C. Enable port security on this interface.
D. Configure multidomain authentication
on this interface.
Answer: D

Question 6:
While troubleshooting high CPU utilization
on one of your Cisco Catalyst switches, you
find that the issue is due to excessive
flooding that is caused by STP.What can
you do to prevent this issue from
happening again?
A. Disable STP completely on the switch.
B. Change the STP version to RSTP.
C. Configure PortFast on port-channel 1.
D. Configure UplinkFast on the switch.
E. Configure PortFast
Answer: E

Question 7:
While troubleshooting high CPU utilization
of a Cisco Catalyst 4500 Series Switch, you
notice the error message that is shown in
the exhibit in the log file.What can be the
cause of this issue, and how can it be
prevented?
A. The hardware routing table is full.
Redistribute from BGP into IGP.
B. The software routing table is full.
Redistribute from BGP into IGP.
C. The hardware routing table is full.Reduce
the number of routes in the routing table.
D. The software routing table is full. Reduce
the number of routes in the routing table.
Answer: C

Question 8:
All switches have default bridge priorities,
and originate BPDUs with MAC addresses
as indicated.The numbers shown are STP
link metrics.Which two ports are forwarding
traffic after STP converges? (Choose two.)
A. The port connecting switch SWD with
switch SWE.
B. The port connecting switch SWG with
switch SWF.
C. The port connecting switch SWC with
switch SWE.
D. The port connecting switch SWB with
switch SWC.
Answer: C,D

Question 9:
Which three statements about the output
are true? (Choose three.)
A. An mrouter port can be learned by
receiving a PIM hello packet from a
multicast router.
B. This switch is configured as a multicast
router.
C. Gi2/0/1 is a trunk link that connects to a
multicast router.
D. An mrouter port is learned when a
multicast data stream is received on that
port from a multicast router.
Answer: A,B,C,

Question 10:
Which technology does the use of bi-
directional BPDUs on all ports in the
topology support?
A. RSTP.
B. MST.
C. BridgeAssurance.
D. Loop Guard.
E. Root Guard
F. UDLD
Answer: C

Our CustomersViews Demonsstrate Our Performance
Hi this is Findlay Ian. I was
worried about my exam and I
was thinking what should I do
now.Then my best friend
John I lham recommended me
this website and he said I am
sure you will pass your exam
if you will follow their
braindumps.
My Name is Lara Dwayne I
Used the Braindumps of
They are providing 100%
Correct Dumps. I passed My
Exam with 950/1000 marks.
Thank you realbraindumps.

We Build Our Customer’sTrust
www.realbraindumps.comThe Name of Trust

Cisco 400-101 CCIE Routing and Switching Certification Exam Training Guide

Recommended

Recommended

More Related Content

Recently uploaded

Recently uploaded (20)

Featured

Featured (20)

Cisco 400-101 CCIE Routing and Switching Certification Exam Training Guide