" How to " questions answer at your fingertips If you’re looking for an answer to a “How to” question, you’ve come to the right place. And if we don’t have an answer, we’ll find it for you.

1. tie a box with a ribbon
You've wrapped your gift and bought it to take away. All you need is an extraordinary bow, and tying a
bow around the box feels prettier and more elegant than using a self-adhesive bow. We'll show you
how tie a ribbon around a box, as well as how to make diagonal bows and fancy braids around your gift
box!
Lay the tape horizontally
tie ribbon on gift Leave about four to eight inches (10.16 to 20.32 cm) of space on the tail side of the
bow. Don't cut the band just yet.It's better to leave a lot of unsightly tape than too little. You can
always cut it shorter later.Pull the remaining tape under the cardboard and lay it down forward.Don't
flip the field or you might lose your position too. Instead, lift the litter tie a ribbon around a box and
apply the remaining tape to the back. Once the tape comes out on the other side, turn the box upside
down.
Thread the ribbon across the entire front of the box.
Pull the tape towards the center of the tie ribbon on gift, then the shorter pieces until they meet. Wrap
the straps together so they are aligned vertically. If your cleats have right and wrong sides, you may
also need to turn them twice so you don't see the wrong side of the cleat.

2. Wrap the tape around the back of the panel and bring it to the front.
Raise the field again. Pull off the back of the how tie a ribbon around a box and the longer piece of tape
on the other side. Replace canister. Place your thumb on the opposite side of the bend so it doesn't
hurt as you wrap the tape around the back.Measure the tape opposite the first piece and reduce.Place
the bottom of the tape near the center of the how tie a ribbon around a box. Measure it from the end
of the tape you set and cut it off.
Wrap the ribbon under the twisted section.
Pull the tape along the front of the angled twisted section. Put it under the curved part and work your
way down from where it started. Pull each end of the ribbon to tighten the knot.
tie the ribbon into a bow
Fold each end of the tie ribbon on gift into a loop. Cross the left loop over the right to make a smaller
loop in the middle. Pull the left loop through the smaller loop and pull tight.

3. Align the loops, then cut off the excess ribbon.
Take a moment to change the loop and tail. If you're using ribbon, you can also loosen the loops. For a
more elegant touch, reduce the end of the tail to an angle or Vs.
How to Tie a Perfect Bow with Ribbon
you did it! You've chosen the ideal stream for your loved one and even found the wrapping paper. Now
for the finishing touch: take a bow! Anyone who's ever used tie a ribbon around a box knows that tying a
bow can be a challenge, but it's sure to add something unique to your gift. Grab your tape, and scissors,
and let's get started. Follow these easy steps and wow your recipients. You'll use these tips to make
Christmas gifts, wedding tie ribbon on gift, birthday gifts, and more.
1.Press down on the tape on the box with your thumb. Wrap the ribbon around the width of the
package. Wrap it around the tape you are holding.
2.Continue to do the cycle. Pull the piece you're holding through the center. Wrap another piece over it
and pull it under the middle. Pull the pieces at the ends to tighten the knot.
3.Create an arch at the same height as the tape. Wrap the other end of this ribbon around this loop.
Underline and pull to form a 2D loop. Pull each loop to form a loop, making sure they are even.
4.Fold the sling plug in half lengthwise and cut diagonally to form two sharp points. Repeat the above
steps on the other dangling tie a ribbon around a box