2. We Assumed a 4 Storey Building for
Working in a Height
3. SAFETY CRITERIA SAFE UNSAFE % SAFE
1. GUARD RAILS SYSTEM
Top rails
• Height of top rails should be 42 inches (1.1 m) plus or minus
3 inches (8cm) above the walking/working level.
1926.502(b)(1)
Mid rails
• Mid rails should be installed between the top edge of the guard
rail system and walking/working surface when there is no wall
or parapet wall at least 21 inches (53cm) high. 1926.502(b)(2)
Toe boards
• Toe boards should be at a minimum of 3.5 inches (9 cm) in
vertical height from their top edge to the level of the
walking/working surface. They shall have not more than 1/4
inch (0.6 cm) clearance above the walking/working surface.
1926.502(j)(3)
75%
88%
75%
4. SAFETY CRITERIA SAFE UNSAFE % SAFE
2. PERSONAL FALLARREST SYSTEM
Anchorage connector
• Connector shall have a corrosion-resistant finish and all
surfaces and edges shall be smooth to prevent damage to
interfacing part of the system. 1926.502(d)(2)
• Connectors should be pressed or formed steel or made of
equivalent materials. 1926.502(d)(1)
63%
5. SAFETY CRITERIA SAFE UNSAFE % SAFE
Body belts
• Body belts shall be at least one and five-eight(1 5/8) inches
(4.1 cm) wide. 1926.502(d)(22)
Connecting devices
• Lanyards and vertical lifelines shall have a minimum breaking
strength of 5000 pounds (22.2KN). 1926.502(e)(5)
• Lifelines shall be protected against being cut or abraded. 1926.
502(d)(11)
63%
38%
6. SAFETY CRITERIA SAFE UNSAFE % SAFE
3. SAFETY NET SYSTEM
Safety net shall be installed as close as practicable under the walking
/working surface on which employees are walking.1926.502(c)(1)
Safety net shall extend outward from the outermost projection of wo
rk surface. 1926.502(c)(2)
50%
7. Score sheet used in 4 Storey Building as trial
CRITERIA CORRECT TOTAL INCORRECT TOTAL %SAFE
1 GUARD RAILS SYSTEM
i. Top Rail
6 2 75%
ii. Mid Rail 7 1
iii.Toe Board 6 2 75%
2. PERSONAL FALL
ARREST SYSTEM
i. Anchorage connector 5 3 63%
ii. Body belts 5 3 63%
iii. Connecting Devices 3 5 38%
3. SAFETY NET SYSTEM 4 4 50%
Total Correct 36 Total Incorrect 20
Safety Score:
Total "correct
Total "correct" + Total "Incorrect"
X 100 = 64.28%
8. • Inspect before each use. Fall protection exhibiting any of these faults shall be removed from service and destro
yed.
• Take photo of unsafe behavior and condition during construction.
• Record these files in the documents.
• Explain worker about unsafe activities by showing the record.
• Apply Fall Protection Training.
• A fall arrest occurs on site, personnel, using an articulating man lift or ladders where feasible, will rescue all em
ployees. Alternate rescue would be through local emergency services.
• All fall investigations will be conducted by (insert the title{s} or name{s} of person).
• Evaluate the fall protection program to determine its effectiveness.
• Staff feedback and interviews.
• To follow the guidelines set forth in this fall protection program.
Corrective Actions should be taken by safety supervisor