1.
Content is © Amy Celona (www.ustamp4fun.com) and all images © Stampin’ Up! Not for redistribution or for publication
Men’s Vest Card
By Amy Celona, www.ustamp4fun.com
Set(s): Wanted
Accessories:
8 ½ x 5 ½ Close to Cocoa cardstock
4 x 4 inch To the Nines DSP brown paisley
2 ½ x 2 ½ inch To the Nines DSP brown paisley
3 x 1 inch To the Nines DSP green w/brown dots
Mini silver brads
Close to Cocoa ink, sponge daubers
Vanilla taffeta ribbon, ¾ inch square punch
1 1/16th
inch hole punch, ¾ inch hole punch, Dimentionals™
1. Holding the Cocoa cardstock ‘landscape’, fold
the right and left edge into the center to form a 3
panel card.
2. Take the cardboard template and trace the ‘vest
panel’ on each front flap, and then cut through to
the back to make the card appear to be a
sleeveless vest
3. Take the 4x4 piece of brown paisley cardstock
and adhere it to the inside of the card. Close the card and cut off the designer paper where the sleeve notch
is.
4. Take the collar cardboard template and cut TWO
MIRROR IMAGE sides of the front collar
IMPORTANT: remember to flip the collar
template over so that you have matching ‘mirror
image’ collar pieces. Adhere these collars on the
middle top with Dimentionals™ and monoadhesive
and then cut out the ‘V’ of the neck. DO NOT set
the silver eyelets in.
5. Take the tie template and cut out the tie and adhere
with the green dotted side up, tucking it under the
collar. Take the ¾ inch circle punch and adhere it
at the top of the tie (like where the tie knot would
be).
6. With everything properly in place inside, take the 1
1/16th
inch hole punch and set the mini silver brads.
7. Lay the card open flat (inside down) and stamp the
paisley on the two vest flaps. Gently sponge the
vest side edges.
8. Punch a ¾ inch square and cut the bottom two corners to form the pocket. Sponge the edges. Cut a ½ inch
piece of vanilla taffeta ribbon and adhere to the back side of the ‘pocket’ securely and then adhere the
pocket to the vest front.
9. Use the pencil to mark 3-4 evenly spaced holes on the left vest panel edge and set mini silver brads.

2.
Content is © Amy Celona (www.ustamp4fun.com) and all images © Stampin’ Up! Not for redistribution or for publication
Men’s Vest Template
Shared by Amy Celona, www.ustamp4fun.com