Ce diaporama a bien été signalé.
Nous utilisons votre profil LinkedIn et vos données d’activité pour vous proposer des publicités personnalisées et pertinentes. Vous pouvez changer vos préférences de publicités à tout moment.

Anodized aluminum measurement

4 403 vues

Publié le

Aluminium oxide (Alumina)is widely used as protective coating in various application. Optical alumina mainly depends on deposition condition. probe system is used to measure both thickness and optical constant.

Publié dans : Ingénierie
  • Soyez le premier à commenter

  • Soyez le premier à aimer ceci

Anodized aluminum measurement

  1. 1. 83 Pine Hill Rd. Southborough, MA 01772 Phone +1.617.388.6832 Fax. +1.508.858.5473 email: info@semiconsoft.com http://www.semiconsoft.com Thin Film Measurement solution Software, sensors, custom development and integration THICKNESS MEASUREMENT OF ANODIZED ALUMINUM LAYER Anodizing is an electrochemical conversion process that is widely used for many applications. Unlike most protective coatings, anodizing permanently changes the outer structure of the metal. The alumina layer formed during anodizing has hardness similar to a diamond and high abrasive resistance. Anodizing is, typically, ranges from 0.5 μm to 100 μm thickness. Three most common aluminum anodizing include chromic (type I),sulfuric (type 2) and hard (type 3). Type 1 (chromic acid electrolyte) yield the thinnest coating (0.5 – 3 μm) and has least effect on the fatigue strength. It is most frequently used in military and aerospace application Type 2 (sulfuric anodizing) yields thickness up to 25 μm . This anodizing most frequently used for decorative purposes. Type 3 (hardcoating anodizing) uses higher concentration of sulfuric acid at lower temperature resulting in the thick (~ 100 μm) coating with the tough outer skin. This type of anodizing is frequently used for building materials, photocopiers paper rolls, etc. Anodizing process parameters have a significant influence of the thickness the formed layer. Through various process controls and thickness measurement Anodizers are able to control and correct the anodized coating applications. This is especially important for the thin (Type 1) anodizing. Clear anodized layer thickness can be easily measured with MProbe 20 spectroscopic reflectometer. The non-destructive optical method allows quick (< 1s) measurement on different surfaces. Fig. 1 Anodized Aluminum part (Type 1 anodizing)
  2. 2. 83 Pine Hill Rd. Southborough, MA 01772 Phone +1.617.388.6832 Fax. +1.508.858.5473 email: info@semiconsoft.com http://www.semiconsoft.com Fig. 2. Reflectance spectra measured at 4 different points, wavelength range: 450-1000nm. The oscillations (interference) in the spectra indicates the presence of the layer Fig. 3. The part of the spectrum (510-800nm) that contains most useful information and was used for the measurement.
  3. 3. 83 Pine Hill Rd. Southborough, MA 01772 Phone +1.617.388.6832 Fax. +1.508.858.5473 email: info@semiconsoft.com http://www.semiconsoft.com Fig. 4 Results of the measurement. Peak position indicates the thickness of the Anodized layer. The value of the thickness is displayed in the table Point Thickness, µm 1 (center) 5.314 2 5.093 3 5.093 4 5.093 Table 1. Results of the measurement in 4 points across the surface

×