2. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
It's hard to find the strength of CS. People often use a TDS meter.
However, colloidal silver is silver particles that are suspended in
solution – only silver ions are dissolved. So TDS meters will only
measure the ionic silver strength, not the colloidal strength.
TDS meters measure the conductivity of water, and convert ohms
to ppm.
3. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
The CS that Spooky2 makes has an exceptionally high ratio
of CS to ionic silver. The calculator takes the initial TDS
reading (only the distilled water – this should be 1 or less)
and compares it with the later/final TDS reading.
From the difference in readings, Spooky2 ascertains the true
amount of silver (in ppm, or parts per million) that is in
solution.
A more accurate way of determining the ppm is to use a multi
meter set to milliamps.
4. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Before you begin, set it all up and start a program using any
dwell multiplier. Measure the current that passes through one
of the rods by putting the multi meter in series.
This means removing a clip connected to one of the silver rods
and attaching it to one of the multi meter leads. When the other
multi meter lead touches the rod you removed the clip from, a
current will be shown.
5. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Entering this current value into the calculator along with the
volume of the water will give a good estimate of the time
necessary to make CS.
The current that passes through the solution increases over
time as more silver sloughs off the rods. The purpose of the
10k resistor is to keep the current more constant and low.
6. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
7. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Thank you!