Toyota 6 hbw20 electric pallet jack walkie walk service repair manual
Service and Parts Manual
TOYOTA
Model Serial No.
6HBW20 10011 and Up
Date: 10/01/95
Service and Parts Manual TOYOTA
Introduction
PREFACE
This manual indudesinformationrequired for maintenance, troubleshooting, and
repair of the Model 6HBW20. The objectis to insuresafe maintenance and repair
practices and procedures for this Toyota product.
MANUAL OVERVIEW
This manual consists of both a ServiceManual and a PartsManual for the specific
equipment listed on the cover.
The Table of Contentsprovides easy location of all subject matter within the
manual.
The followingsymbols are used throughout this manual to represent a condi-
tion or hazard of which the operator should be aware.
DENOTES A SERIOUSHAZARDTHAT COULD CAUSE INJURYOR DEATH TO THE
OPERATOROR OTHER PERSONNEL FROMA PARTICULARACTION OR
CONDITION.
DENOTES A LESSSERIOUS HAZARD FROMAN ACTION OR CONDITION THAT
ACAUTlON COULD CAUSEMINORINJURY TO THE OPERATORORMAINTENANCE
PERSONNEL, OR CAUSE DAMAGE TO THE EQUIPMENT ITSELF.
Denotes a particular statement pertaining to a particular procedureor explanation.
Revised text and illustrationsare indicated by a black vertical line along the
left-handmargin of the page, oppositerevised, added or deleted material. Revision
linesindicate only current revisions with changes and additionsto or deletions of
existing text and illustrations. Changes in capitalization, spelling, punctuation,
indexing, the physical location of the material or complete page additions are not
identified by revision lines.
Copyright @ 1995 by Toyota lndustrial Equipment, a Division of Toyota Motor Sales,
U.SA., Inc.
All rights reserved. No portion of the manual may be reproducedmechanically,
electronically or by any other means, induding photocopying, electronic retreival or
transfer, or recording without the written permissionof the publisher.
Toyota lndustrial Equipment believesthe informationin this manual is accurate and
current as of the publication date; such information is subject to change without
notice. Toyota lndustrial Equipment is not responsiblefor any errors that may
appear in this manual.
Service and Parts Manual
S~ecialService Tools TOYOTA
viii
Tool List
00590-04661-71
00590-04667-71
00590-04668-71
00590-04669-71
00590-04670-71
00590-04671-71
00590-04672-71
00590-04673-71
00590-04674-71
00590-04675-71
00590-04676-71
00590-04677-71
Description
Diagnostic Service Tool (Programmer)
Pin Extractor
Pin Extractor
Pin Extractor
Pin Extractor
Crimping Tool
Extraction Tool
Model 1141 FasTest Accessory
Model 1142 Tester
Curtis Battery Book One
Bearing/Sealing Ring Installation Tool
Battery Pack Lifter
Service and Parts Manual
General Information TOYOTA
General Mainte- Industrial vehicles may become hazardous if adequatemaintenance is neglected.
nance Instructions Only trained technicians, using approved procedures, in adequate maintenance
facilities should work on this or any other industrial vehicle.
Maintenance Prac- 1.Follow a scheduled lubrication, maintenance, and inspection schedule.
tices
2. Only qualified, authorized technicians are permittedto inspect, maintain, adiust,
and repair this vehicle.
ACAUTlON REMOVE RINGS, WATCHES, AND ALL JEWELRY BEFORE DOING ANY WORK ON
VEHICLE.
3. Before working on vehicle:
a. Lower load handling mechanism completely to the floor.
b. All controls must be in neutral.
c. Release any trapped pressurein hydraulic systems.
d. Block the wheels to prevent movement of the vehicle.
e. Disconnect battery connector
f. Elevate drive tire off floor.
USE EXTREME CARE WHENEVER THE VEHICLE IS JACKED UP FOR ANY REASON.
KEEP HANDS AND FEET CLEAR FROM BENEATH VEHICLE WHILE JACKING. USE
JACK STANDS OR SOLID BLOCKS TO SUPPORT VEHICLE - DO NOT RELY ON
JACKS.
g. Before working on load handler, support to prevent movement.
4. After working on vehicle, test all controls and functionsto assure proper
operation.
5. Work in a clean, dry, well ventilated area.
6. Avoid fire hazards. Have adequate fire fighting equipment in the maintenance
area.
7. DO NOT use open flame or sparking devices around the battery. The gasses
given off by the battery are highly explosive.
8. Use extreme caution when using flammable cleaning solutions.
More information pertaining to operating and maintenance procedures may be
, obtained from:
American National Standards Institute
1430 Broadway
New York, NY 10018
Ask for ANSI B56.1 - 1988
Service and PartsManual
General Information TOYOTA
Specifications
Model: 6HBW20
Battery Voltage: 24 .
Wheel:
Drive: 10.5 x 5"Rubber
Load: 3.25 x 5" Polyurethane 121
Install load wheels with at least 1 shim on each side
and a maximum of V16' (1.58mm) end play. -
-~
Transmission
Fluid: Standard Use 80W-90W
Cold Storage "DEXTRONIIVTF
.FluidCapacity: 0.8 Quart (0.75 liter)
Torque Requirement: Torque drive tire retaining
nut to 250 FT./LBS,
(350Nm) (Whilerotating
drive tire)
Torque pivot bearing retaining nut to Zero (0)end play
on pivot bearings while pivoting transmission. -
Hydraulic
Lift/Lower System
Fluid: Standard Use
Cold Storage
Reservoir Capacity:
Relief Valve Setting:
1OW-40W
"Dextron IIVTF
1 Quart (0.9 liters)
2600 psi f50 psi (177 Barf 3.4 bar)
Service and Parts Manual
General Information TOYOTA
Component Identifi-
cation
Battery
Discharge/Hour
Meter
Key Su
Lift Butt01
Lower Button
, Directional/Speed
Control
Horn Button
Belly Button
~evbrseSwitch
Figure 63 Component Identification
Service and Parts Manual
General Information TOYOTA
Component Identifi-
cation (Cont'd.)
' Battery Charger
Timer
Ban
in C
Battery
Charger
Figure 64 Component Identification (Cont'd.)
4
'1120 VAC Power Cord
(for the vehicle's battery
charger)
Service and Parts Manual
General Information TOYOTA
Forward Reverse 15 Amp Lift
Contactor Fuse Cylinder
Battery Discharge/Hour Meter
Contactor
Battery
Connector
Motor -Controller
Circuit 4
Breaker [CBl
Horn
/
Drive
Unit
Key
, Switch
Hydraulic
Pump
Hydraulic
Reservoir
Lift Limit
Cutoff Switch
Figure 65 Component Identification (Cont'd.)
Service and Parts Manual
General Information TOYOTA
Standard Torque
Data For Bolts
Figure 66 Standard Torque Data for Bolts
6
Thank you very much for
your reading. Please Click
Here. Then Get COMPLETE
MANUAL. NO WAITING
NOTE:
If there is no response to
click on the link above,
please download the PDF
document first and then
click on it.
Service and Parts Manual
General Information TOYOTA
Decals The followingpages show proper mounting and location of decals.
NOTE: See the Parts Manual for decal description and ordering information.
a" 1:
VlEW A
a
2.50' (6.35 cm) 1.2SD(3.17 cm)
4
VlEW A
Decals:
1. Emergency Disconnect
2. Caution-Bilingual
3. No Riding
4. Spec Plate U.S.
5. PocketManual
6. Warning
7. Cold Storage (located next to lift pump.)
Figure 61 Standard Decal Placement