4. Step 1:
• Firstly, begin by deciding
on a particular size for the
wooden toolbox. As a
suggestion, try making it
a little bigger so that it
can accommodate longer
tools easily.
• Now ensure that wood for
the box has square ends.
Use T-square to mark
lines about an inch from
the end and trim them
down with a saw.
5. Step 2:
• Once done with trimming
the wooden squares,
measure and begin
cutting them.
• Because, the bottom and
side of the toolbox will
have caps in the ends,
you need to cut them a bit
longer than other pieces.
6. Step 3:
• Precisely design the end
pieces and cut them.
Measure six 1/4′’ to the
bottom of 1×10 section
and spot it on two banks
of the board.
• Connect the mark at 6 ¼’
with the arc and repeat
the same for the other
side.
7. Step 4:
• Place the compass on
11” mark and draw a
circle at 1 ¼’ mark hole.
Cut out this section using
a pull saw.
• Drill a hole in the handle
using brace and bit. Make
sure that that you place
the center screw in the
midpoint of 11” mark.
8. Step 5:
• Use a rasp and clean the
top of side piece.
Remember to repeat the
whole thing for the other
section and you can use
the first one as a stencil.
• Attach the end pieces to
the end of the board and
screw them tight.
9. Step 6:
• Place the edge of side
section over the end of
bottom plank and screw it
accurately. Make sure
that you drive screws
deep into the surface.
• Use wooden glue to the
section and hammer to
make the joints stays
resilient.
10. Step 7:
• By now you will have a
good frame for the
toolbox. Simply add the
longer sections between
the two the triangular
faces.
• Use sand paper and
provide proper finish at
the ends, especially the
handle of the toolbox.