5. HOW TO MAKE IT:
1. Cut the chopsticks with a lenght of 16 cm, which is then split in the middle
leaving a little to not split.
2. Cut the raf
fi
a rope with the same size, then give the chopped chopsticks
fox glue. continue by sticking the raf
fi
a rope inside the chopped
chopsticks.
3. If done, tie the chopsticks on the side with a crack rope to lock it.
4. Thead the raf
fi
a string with a needle
5. peel off the bottom of the two bottle caps and combine them into one
using wax glue. then the middle part is gavin a hole
6. after that, attach the lid to the chopsticks.
6. 7. Next , make a pattern by cutting two pieces of cardboard measuring 20 cm
long x 4 cm wide on the right side. Then given hole in the middle of the left
side.
8. Insert the straw into the hole and give it wax glue, then cut off the excess
straw.
9. Make the
fi
rst cardboard pattern with a leangth of 13.5cm and a width of 6cm.
10. After that, fold the cardboard paper in the middle, then stick the second at
the end with fox glue.
11. Attach the
fi
rst cardboard to the back of the frame using wax glue.
12. Then, install the cardboard measuring p20 cm x L4cm on the left side x L 6cm
on the right side on the side. Then install the chopsticks that have been
assembled into the holes of the cardboard pattern.
7. 13. After that, stick the dc dynamo to the side of the bottle cap, then install rubber to
connect the dynamo to the bottle cap.
14. Prepare the
fi
rst cardboard pattern with a lenght of 12cm and a width of 3cm to
pieces, the third with a lenght of 4cm and a width of 4cm two piaces.
15. Attach the push swicth to the
fi
rst cardboard, then weave the cardboard patten into
a beam.
16. connect the push switch cable with the batery socket. Then stick the cardboard
beam to the middle of the back of the main circuit with a hole. Then connect from
batery socket to the dynamo.
17. Make a cardbord pattern measuring 20cm long and 11.5cm. Then stick the mica paper
on it.
18. After that, attach a toothpick to the edge of the 4 corners with wax glue. Then
install it at the top of the main network.
19. Done