This document provides assembly instructions for a modular multi-purpose health and safety station in 3 steps: 1) Unpack the contents of the box and move the box to the designated assembly point. 2) Lift the board on top of the supports and fix the supports with the provided fixings by hand tightening them. 3) It is recommended to fix the accessories while the board is lying flat for easier alignment using the provided fixings.

1. Assembly
instructions
A mobile,modular multi-purpose H&S station,delivering clear and up-to-date H&S information and
consumable personal protective equipment.
You will need a fellow worker,
and a 15mm wrench key.
Optional equipment: water source
with hose and 8mm concrete drill.
I
15
φ8
(00 44) 20 3532 0639
sales@ramsboards.com
www.ramsboards.com
Company No. 08792619
VAT registration number: GB 191 3128 21
RAMS Boards Ltd.
3 Crocus Field, Barnet,
Hertfordshire, EN5 2UA,
United Kingdom
IV
Recommended layout of accessories.
To move the RAMS board to new
position it is recommended to unbolt
the top display board from the support
legs first,to prevent an unsafe
condition whilst moving the board.

2. II III
Move the box to the designated assembly point.
Unpack the content of the box.
Do not forget to recycle packaging.
approx.160cm
Lift the board on top of the supports
Fix supports with fixings provided.
Hand tighten.Do not overtighten.
For stability fill supports with water.
Filling point is located at the top-inside
part of the support.
Discharge point is located
at the bottom-inside part of support.
To fully prevent overturning possibility,
anchor the supports with holding down
bolts to the ground.Use fixings provided.
φ8
×4
It is recommended to fix accessories
while board is lying flat for easier
alignment.Please use fixings provided.
×4
×4
15