Bending BWS primer
•Télécharger en tant que PPT, PDF•
7 j'aime•1,295 vues
A primer in wire bending skills and instructions to create a Farrell Bent Wire System lightwire expander. Designed for practitioners with little or no bending experience.
Recommandé
Contenu connexe
Tendances
Tendances (20)
Similaire à Bending BWS primer
Similaire à Bending BWS primer (20)
Plus de The Raphael Center for Integrative Education
Plus de The Raphael Center for Integrative Education (20)
Dernier
Dernier (20)
Bending BWS primer
- 1. Learning to Bend wire Purpose: To give you the skills and confidence to make and use the Farrell Bent Wire System
- 2. 1) Unbend a paper clip...by hand
- 13. Supply Tray Model (with Bands) Pencil, Marker Bird Beak Heavy Wire Cutter .028 SS wire
- 15. Visualize the contact points
- 16. Mark points of contact
- 18. Put marked model on the photocopier
- 19. Cover with cloth or paper towel
- 20. Photocopy
- 22. Keep the model nearby for reference
- 23. Start in the midline
- 25. ...keeping the wire flat.
- 27. A little overbent, so...
- 29. Follow along the line
- 31. Take it to the model
- 33. Mark points of contact
- 35. Visualize the contact points
- 36. “ Spin” the wire and adjust to the the contact points
- 37. From the side
- 38. Done
- 40. Mark the model where you want contact where you want contact
- 41. Start bending from the midline, work right, then left
- 43. Make sure it lies passively
- 44. Go to the other side
- 45. Bending the Loop
- 46. Locate point for Loops
- 47. Mark the wire
- 48. Pick up next to the mark...
- 49. ...round beak toward bend
- 50. Set the angle of the loop Plane of the BWS (occlusion) Plane of the bend: always perp to plier Upper = 25 o Lower = 10 o
- 51. Bend around the round beak
- 52. The first bend: small 90
- 53. Ready for the second bend
- 54. 2nd Bend: large 180
- 55. The Second Bend
- 56. Next: Small 90
- 57. Third bend
- 58. Next: Small 180
- 59. The Fourth Bend
- 60. the Fourth Bend
- 61. Adjust loop and distal leg
- 62. Adjusting the Legs: Horizontal plane
- 64. Adjust Angle of Loop Gingival Impingement
- 65. Adjust angle of loop
- 66. Adjust the Legs: Vertical plane
- 67. Loop’s too high
- 68. Now tipped down
- 69. Good
- 70. Cut off extra
- 71. One last case...
- 72. Adapted BWS
- 73. Make your marks
- 74. From above...
- 76. Start your bends and adjust
- 78. ...set aside for try-in.