1. http://msshouston.com/

2. Steps to Make a Pipe Rack
Pipe shelves are utilized to store
and display tobacco pipes. They're
frequently present in smoke
lounges, cigar areas and
gentlemen's rooms. Pipe shelves
are frequently simple in design,
however construction can need a
fair quantity of calculating and
cutting. Building your personal pipe
rack is going to be less costly than
purchasing one in the store. When
building your personal pipe racks it
may be beneficial to utilize a decorative hardwood like oak. Oak won't be
durable but it'll match the good thing about the wood in your pipes.
1. Lay lower a 16-inch board flat and horizontal. Draw a line across the
middle of the board so it's 1.5 inches from each 16-inch edge. Draw five
lines perpendicularly over the first line so that they are spread 3 inches
apart, using the two outdoors lines 2" from the finishes from the board.
Draw single or 8-inch circle where each one of the lines intersect. Continue
doing this process alternatively 16-inch board.
2. Draw single.5-inch dotted line on both sides from the five lines attracted
within the last step. They must be one fourth inch from the lines, beginning
in the 1.5-inch core board and ending around the 16-inch edge. All of the
lines must finish across the same 16-inch edge. You'll have 10 dotted lines.
Continue doing this process alternatively 16-inch board.
3. Drill single-inch hole with the crossing points which have the circles
attracted around them. Your pipe necks will fit with these holes.
4. Cut across the dotted lines together with your band saw before you
achieve the holes which were drilled. These slots can make simple to use
to place pipes around the rack.
5. Squeeze two 6-inch boards on their own 3-inch edges, so that they are
parallel and 16 inches apart. Put the two 16-inch boards perpendicularly

3. together therefore the edges using the slots are facing up and therefore are
5.25 inches apart. Drill four 3/32-inch pilot holes through each 6-inch board,
so a couple of them enter each finish from the 16-inch boards. Each set of
pilot holes ought to be spread 2" apart, and really should go into the
finishes from the 16-inch boards in their 1/8-inch center. Screw it's together
therefore the corners are flush. Use eight 1.5-inch screws.
6. Sand your pipe rack lower together with your medium-grade and fine-grade
sandpaper. Wipe it lower having a tack cloth and apply your wood
stain. Allow the rack dry.
7. Locate studs within the wall in which you would rather hang your pipe
rack. Position your pipe rack from the wall together with your level to
guarantee the 16-inch boards are horizontal. Screw with the plywood and in
to the studs. Use two 3-inch screws.