LAMCO FOREST PRODUCTS: Greener Engineered Woods STRONG Design Values up to 2.0E in Exact Widths 2½"-16", Lengths 5’8"- 32’, in any 1/16" increments. Can substitute dimensional lumber, MSR and even LVL in Modular, HUD, Panel & on-site construction as JOIST, HEADER, BEAM, STRINGER; TRUSS, FLOOR & ROOF COMPONENTS;TALL STUDS up to 32'; 14% or less moisture content & LIGHTER; STRONG Design Values (1.5E,1.6E,1.8E and 2.0E) for substitution up to MSR to 2.0E LVL strength. HIGHER SPANS than lumber NO SPECIAL TOOL needed to drill/nail Can be PRE-DRILLED and Precise End Trimmed REDUCES on site WASTE, LABOR & COST REDUCES WEIGTH & HEIGHT at shipping of modular/manufactured homes DESIGN VALUES in most SOFTWARES of plate connectors Good for FIRE RATED ASSEMBLY (using 1-hr fire rated HEXION adhesive)

2. RELAM – LFS Structural Components

3. 2”x 3” to 2”x 16”

4. RELAM LFS: Pre-drilled option STRUCTURAL COMPONENTS

5. Relam Stud - No twisting -Zero Waste 100% Wane Free Edges !

6. Pre-Drilled Relam Stud

12. LAMFLOOR Structural Rustic Flooring

13. LAMFLOOR

14. Home show, Quebec 2008

15. Visitors walking on Lamfloor, installed at 48” on center in this picture

16. LAMFLOOR Used for CEILING / ROOFING system

17. LAMFLOOR Directly on the joist / beam / log

18. LAMFLOOR

19. LAMFLOOR is Easy to stain Jack Pine shown here

20. Give it the color you want ! Walnut Color on display

21. LAMFLOOR : Oil finish

23. LAMWALL Interior and Exterior Siding

24. 2007 Project

27. LAMWALL: Double Flat

29. LAMWALL: Double Round

33. LAMWALL: Board on Board

34. LAMWALL: Board on Board

36. DECKING

37. Anti slip surface

38. Cupping prevention groves

39. Same length (no mixed lengths required)

40. GREEN ADVANTAGE

44. THE GREENEST BUILDING SOLUTIONS GREEN ADVANTAGE: At Lamco Plant: Waste is re-used or recycled: What is cut from a board is either rerun through production into appearance/non structural products or recycled into wood pellets in a plant adjacent to us. Zero waste of raw material. Proximity to the source: Our plant is close to the forests where harvesting is done and close to 1st transformation plants (our suppliers). Reduction of transportation and energy costs from harvesting to final transformation. Innovative and low energy drying technology: Engineered wood requires high control of the moisture content of raw material, even when purchased kiln dry. Lamco operates its own dryers on low temperature basis using electrical heat pumps. Our electricity supplier, Hydro-Quebec, produces it from renewable sources. Minimum energy consumption. Worldwide unique gluing and pressing process: Lamco’s patented process uses only 1% of glue in its engineered wood, the lowest among all competitors. Minimum adhesive used.

47. CANADA : Steve Mailhot, MBA Director of Sales Tel: 418-679-2647 x 231 Mobile: 418-630-6590 [email_address] USA & International Sales : Mélanie Cauchon, B.Eng. US Sales Manager Tel: 508-534-5570 Mobile: 508-776-5378 [email_address] CONTACT US :

48. For more information visit www.lamcoforest.com THANK YOU Prepared by Mélanie Cauchon, B. Eng. U.S. Sales Manager, Lamco Forest Products Direct: 508-534-5570 Updated 09/10/2009