The document discusses the functions and components of automotive onboard computers. It begins by outlining the objectives of understanding input sensors, output devices, and the general purpose and function of onboard computers. It then describes the four basic functions of all computers as input, processing, storage, and output. It provides details on computer components, communication between modules, and diagnostic procedures.
5. Figure 12-1 All computer systems perform four basic functions: input, processing, storage, and output.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20. Figure 12-2 A potentiometer uses a movable contact to vary resistance and send an analog voltage signal to the PCM.
21. Figure 12-3 A replaceable PROM used in an older General Motors computer. Notice that the sealed access panel has been removed to gain access.
22. Figure 12-4 A typical output driver. In this case, the PCM applies voltage to the fuel pump relay coil to energize the fuel pump.
23. Figure 12-5 A typical low-side driver (LSD), which uses a control module to provide the ground path for the relay coil.
24. Figure 12-6 A typical module controlled high-side driver (HSD) where the module itself supplies the electrical power to the electrical device. The logic circuit inside the module can detect circuit faults including continuity of the circuit, and if there is a short-to-ground in the circuit being controlled.
25. Figure 12-7 Both the top and bottom pattern have the same frequency. However, the amount of on-time varies. Duty cycle is the percentage of the time during a cycle that the signal is turned on.
26.
27.
28.
29. Figure 12-8 Many electronic components are used to construct a typical vehicle computer. Notice the quantity of chips, resistors, and capacitors used in this General Motors computer.
30.
31.
32.
33.
34.
35. Figure 12-9 Typical ignition timing map developed from testing and used by the vehicle computer to provide the optimum ignition timing for all engine speeds and load combinations.
36. Figure 12-10 The calibration module on many Ford computers contains a system PROM.
37. Figure 12-11 The clock generator produces a series of pulses that are used by the microprocessor and other components to stay in step with each other at a steady rate.
38. Figure 12-12 This powertrain control module (PCM) is located under the hood on this Chevrolet pickup truck.
39. Figure 12-13 This PCM on a DaimlerChrysler vehicle can only be seen by hoisting the vehicle because it is located next to the radiator, and in the airflow to help keep it cool.
40.
41.
42.
43.
44.
45.
46.
47.
48.
49.
50.
51.
52.
53.
54.
55. Figure 12-14 A typical bus system showing module CAN communications and twisted pairs of wire.
56.
57.
58.
59.
60.
61.
62.
63.
64.
65.
66. Figure 12-15 Sixteen-pin OBD-II DLC with terminals identified. Scan tools use the power pin (16) and ground pin (4) for power so that a separate cigarette lighter plug is not necessary on OBD-II vehicles.
![OBJECTIVES ,[object Object],[object Object],[object Object],[object Object],[object Object],[object Object]](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)