5. Figure 49–1 The three major portions of the A/C and heat system are air inlet, plenum, and air distribution. The shaded portions show the paths of the four control doors. Continued
6.
7.
8.
9.
10.
11.
12.
13.
14.
15. Figure 49–3 A block diagram showing the inputs to the electronic control assembly and the outputs; note that some of the outputs have feedback to the ECM. See the chart on Page 567 of your textbook.
16.
17. Figure 49–4 A typical cabin filter being removed from behind the glove compartment. NOTE: Some cabin filters contain activated charcoal which absorbs hydrocarbons and helps to deodorize the air as it enters the interior. For best results, use the designated replacement filter.
18.
19.
20. Figure 49–6 Three electric actuators can be easily seen on this demonstration unit. However, accessing these actuators in a vehicle can be difficult. Figure 49–7 The feedback circuit signals the AC control unit with the blend door position.
21.
22. Figure 49–8 A typical blower motor assembly with attached squirrel cage blower. A replacement motor does not include the squirrel cage blower so it needs to be switched to the replacement. Figure 49–9 A “credit card” resistor used in the rear blower assembly in a Dodge minivan.
23.
24. Figure 49–10 A dual climate control system showing the airflow and how it splits.
25.
26.
27. Figure 49–13 A sticker on a vehicle equipped with rear heat and air-conditioning warning that a special service procedure is needed when replacing engine coolant.