Environmental friendly two stroke engine

1. c
CAREER POINT UNIVE
MAJOR ASSIGNMENT
Environmental friendly two stroke
engine

2. ~ Function of Two Stroke Petrol
Engine The functionof a two stroke
petrol engine is to deliverpower
to thecrankshaft joined with the
rotary wheel with theuse of
working substance as Petrol
(Gasoline)enteredthrough inlet
port (Carbureter) whichis ignited
inside the cylinderthrough the
spark plug and remaining
substance is released through
exhaust port. This whole process
is completed in one revolution of
flywheel.

4.  When the piston moves upward
a partial vaccum is created in
the crank case until its lowers
edge uncovers the inlet port
completely as shown in Fig.(A)
 The pressure difference set up
between the atmosphere and
crankcase will suck the petrol-
Air mixture through the
carburetor fitted to inlet port into
the crank case.
 The suction will be continued till
the inlet port is covered by the
piston during its next downward
stroke.

5.  After the inlet port is covered by
the piston as shown in the Fig.
(B) , its further downward
motion will compress the
Charge ( Petrol-Air Mixture ) in
the crankcase upto the top edge
of the piston uncovers the
transfer port as shown in fig.
(B).
 The Compressed charge flows
from the crank case to the
cylinder through transfer port.
 The electric spark ignites the
compressed charge . The
combustion of charge will
release hot gases which
increase the pressure and
temperature in the cylinder .

6.  The high pressure combustion gases
force the piston downwards .The piston
performs the power stroke till it uncovers
the exhaust port as shown in the figure.
(B)
 The combustion gases which are at a
pressure slightly higher than the
atmosphere pressure escape through
the exhaust port .
 The piston uncovers the transfer port
.The fresh charge which enters the
cylinder pushes the burnt gases so
more amount of exhaust gases comes
out .
 This sweeping out of exhaust gases by
the incoming fresh charge is called
scavenging

7. In this stroke the piston moves from BDC
to TDC . It covers the transfer port as
shown in the Figure ( c ) .
After the above situation the supply of the
charge is stopped and then when it moves
further up it covers the exhaust port
completely as shown in Fig.(D) stops
scavenging.Upward motion of the piston
will compress the charge in the
cylinder.After the piston reaches TDC the
first stroke repeat again.