This 1999 Intrepid report provides information to permit replacement of interior front door handle or bezel instead of replacing the door trim panel.

1. 1999 Intrepid
Replacement of Interior Front Door Handle
NUMBER: 23-013-04
NOTE: This report replaces the technical service bulletin no. 23-047-02, DATED
SUBJECT:
Interior Front Door Handle/Bezel Replacement
OVERVIEW:
This report provides information to permit replacement of interior front door handle or
bezel instead of replacing the door trim panel.
MODELS:
1999 Intrepid
FAILURE CODE:
P8 New Part
PROBLEM:
An interior front door handle/bezel needs to be replaced.
**PARTS REQUIRED:
Mopar Parts
AR 05102832AA Handle/Bezel, Left, Intrepid, Agate, Trim Codes AZ or D5
AR 05102833AA Handle/Bezel, Right, Intrepid, Agate, Trim Codes AZ or D5

2. AR 05102834AA Handle/Bezel, Right, Intrepid, Dk Camel, Trim Code K9
AR 05102835AA Handle/Bezel, Left, Intrepid, Dk Camel, Trim Code K9
AR 05102836AA Handle/Bezel, Right, Intrepid, Dk Slate, Trim Code DV
AR 05102837AA Handle/Bezel, Right, Intrepid, Dk Sandstone, Trim Code T5
AR 05102838AA Handle/Bezel, Right, Intrepid, Dk Taupe, Trim Code L5
AR 05102839AA Handle/Bezel, Left, Intrepid, Dk Slate, Trim Code DV
AR 05102840AA Handle/Bezel, Left, Intrepid, Dk Sandstone, Trim Code T5
AR 05102841AA Handle/Bezel, Left, Intrepid, Dk Taupe, Trim Code L5
NOTE:
Each kit contains one handle/bezel assembly, six pushnuts and an instruction sheet.
EQUIPMENT REQUIRED:
NPN 21/64 in. (8.3mm) Drill Bit
REPAIR PROCEDURE:
Step 1: with the guidance of section 23 of service manual or the method outlined on
TechCONNECT, proceed by removing the front door trim panel.
Step 2: place the trim door panel on clean work area. Drill out the mounting boss heat
stakes that connects the existing door handle to the trim panel. Remember to take extra
caution to drill exactly in the center of each heat stake.
Step 3: after drilling, remove the existing handle/bezel from trim panel.
Step 4: get rid of the plastic fillings at the back of the trim panel.
Step 5: set the new handle into its position.
Step 6: fasten the nuts into the handle/bezel bosses.

3. Step 7: push the nuts all the way down by using a 10mm socket on the mounting
bosses. This is to secure firmly the handle/bezel into the door trim panel. Check it by
wiggling left and right the handle to ensure if it snug-fit.
Step 8: install the lock switch you got from the original handle/bezel into the new one.
Step 9: re-install the door trim panel following the same procedures outlined on
TechCONNECT or those that can be found on section 23 of the service manual.
POLICY:
Covered with refund within the provision of the warranty.
TIME ALLOWANCE:
23-42-45-92/93 Replace Front Door Handle, Right or Left 0.4 Hrs.