Audio-Technica AT-LP 60 Belt Configuration
•
9 j'aime•61,449 vues
Installing the belt on the AT-LP60 and AT-LP60-USB Turntable.
Recommandé
Recommandé
Contenu connexe
Similaire à Audio-Technica AT-LP 60 Belt Configuration
Similaire à Audio-Technica AT-LP 60 Belt Configuration (15)
Dernier
Dernier (20)
Audio-Technica AT-LP 60 Belt Configuration
- 1. Installing the belt on the AT-LP60 and the AT-LP60-USB
- 2. Open the dust cover and remove the felt mat.
- 3. Remove the platter by placing your thumb and finger in the two center holes and gently lifting the platter off the center spindle.
- 4. On the underside of the platter, place the belt around the drive rim that is located about 1 3/4 inches in from the outer edge of the platter. Make sure it is flat around the rim with no twists.
- 5. Please note the platter with the belt installed.
- 6. Replace the platter and turn it until one of the rectangle holes is at the 10 o’clock position exposing the brass drive pulley.
- 7. Grasp the belt between your thumb and index finger and pull it toward and place it around the brass pulley, making sure not to twist the belt. Make sure the belt is fully in the groove of the pulley.
- 8. Please note the belt properly installed around the pulley.
- 9. Place the mat back on the platter. Now you are ready to use your turntable.