Schéma de principe de la connectivité des systèmes ANTISMOG
ANTISMOG CAR DESIGN REF 2019061501
1.
2. Resume de projet / project summary
Installateur authorisé / authorised installer CAR DESIGN STYLING
Adresse / address Ozoir-la-Ferriere (77), France
Date d’installation / field installation date 08/06/2019
Vehicule / vehicle Peugeot 5008 2014 75000 km 1,6 litre diesel
info@antismog.co
4. Évaluations qualitatives / Qualitative feedback
L'opacité de ce moteur était déjà faible, avant
l'installation. Les mesures d'opacité montraient K
= 0,01-0,02.
Après l'installation, les gaz d'échappement sont
devenus beaucoup moins irritants, ce qui a été
immédiatement noté par le personnel du garage.
The opacity of this particular engine was already
low, before the installation. The opacity
measurements showed K = 0.01-0.02.
After the installation, the exhaust gases became
much less irritant, which was immediately noted
by the garage personnel.
info@antismog.co
5. Notes particulières / Special notes
L’appareil a été installé au «taux de production de
gaz fixe» et n’était pas connecté au capteur
debimetre. Le courant de l'appareil a été défini à
2 ampères.
The device was installed in the ‘”fixed gas
production rate” and was not connected to the
MAF sensor. The device current was set at 2
Amps.
info@antismog.co